Problem: When trying to send data between the DNC server and the CNC, the received data is garbled.
This is most likely caused by incorrect baud rate or data bits settings.
Refer to the RS232 setup page in your control or to the CNC's manual for further information.
Refer to the RS232 setup page in your control or to the CNC's manual for further information.
Refer to the RS232 setup page in your control or to the CNC's manual for further information.
Set machine to ASCII/ISO, or select EIA in the port configuration.
Refer to the RS232 setup page in your control or to the CNC's manual for further information.